One of the main tasks when installing podrozetniki in drywall is to put them in such a way that the sides do not protrude much and do not interfere with the wall. How can I do that?
In fact - very simple. To do this, you need a hand-held battery milling cutter and a quarter milling cutter with a bearing. The meaning of this method is to transfer the plane of the socket itself deep into the wall.
Thus, during subsequent processing of the wall surface from gypsum board (namely, during puttying), the spatula will not cling to the protruding parts of the socket. Everything will be neat and beautiful.
How to properly install podrozetniki in drywall
First of all, it will be necessary to drill holes in the plasterboard for the undergrowths - for this, a crown of a suitable diameter is used. After that, using a hand mill, you need to make a recess for the socket.
Then, using a special planer for processing drywall, it is necessary to remove the "pile" from the paper that formed after the manual milling cutter.
Well, then the rosettes are installed, and you can begin to putty. The disadvantage of this installation method is the formation of a large amount of dust when using a milling cutter. And, in principle, you can walk with a regular stationery knife in a circle around the hole - it will turn out cleaner, faster and much easier.
What do you think about this? Share your opinion in the comments below the video on our website.
