Simple soldering station

Pin
Send
Share
Send

In modern imported soldering irons, the problem of overheating is often identified. And in domestic, sometimes underheating is observed, it is also observed during voltage landing. In this article I will tell you how to solve these problems and also make soldering more comfortable. Using the soldering station, you can work with a large voltage drop, quickly heat the soldering iron and set any temperature you need. So, let's transgress. For a long time I searched the Internet for the simplest station diagram. All in the end they were difficult to perform. The thing ended up being my own.
Soldering Station Diagram:

We will need:
1. Dimer. (anyone will do). It is also called a dimmer.
2. The diode bridge.
3. Case. (wooden or plastic box). It is best to buy a ready-made housing in an electrician.
4. Socket.
5. A plug with a wire.
Let's start with the dimer. Since the case of the dimer is very large, I recommend disassembling it, leaving only the circuit itself. The pen can be replaced, as in my case, you can leave your own.

As a case, I decided to take a box from under the Soviet switch. Since there was no cover, I made mine from plywood.

Now you need to assemble everything according to the scheme. Install a power outlet, plug.

For beauty, I recommend painting the item.

Here is the end result.

I WISH SUCCESS !!!

Pin
Send
Share
Send

Watch the video: DIY Simple Soldering Iron at Home (November 2024).